i believe this is already possible…
but you need to change the parameter ranges of the Manual FX of your controller
ie…
if your Manual FX midi fader/knob is set to chan 1 cc 5, you need to change the parameter numbers between 0-127 and take note of the value that causes the changes between the FX..
usually the first FX is 0 and the last FX is 127 the parameter numbers in between are where the changes occur..
once you know the number range of each FX you need to map them using your specific controller’s editor and map the ranges individually..
i did something similar but using the “scrub” function, to jump around in a song with button presses, its the same method that you could apply to mapping FX, or FX lengths
look at the video i posted on this thread…
again the method of mapping FX is the same
but requires the mapping editor software of your controller in order to do it…
if your controller does not have a midi mapping editor or allow you to change parameters or midi button type… then you are at the mercy of the developers prioritization time line
